Thursday 6 October 2016

U.FL to SMA pigtail cables - let's get them right.

As a leading supplier of antennas, we have built up a reputation for supplying quality RF coaxial cabling solutions to complement our antenna offering and in doing so now have a significant part of our customer base that only sources coaxial cables from us. By having automated cable preparation and termination functions in-house means we can often quickly and reliably supply RF coaxial cables to customers requirements.

One subject we have noticed that confuses our customers, is U.FL to SMA pigtail or adapter cables. Some customers tend to have difficulty to identify what is a SMA Plug, SMA-Jack, RP-SMA etc. The U.FL bit is OK so here are few pointers to the SMA at the other identified correctly!!

A standard U.FL to SMA cable for us is a U.FL to SMA-Female Jack Bulkhead or Panel mount on 1.13mm coaxial cable. It looks like this:

M2MAC-UF-10-SFP

In drawing form, the adapter cable above would look like this:






Cable measurements vary, but we calculate the cable length excluding the connectors to eliminate any doubt.

The U.FL pigtail can connect to SMA-Male Plug at the other of the cable- typically hex barrel, thread inside with a pin:

SMA-Male Plug

The U.FL pigtail can connect to a SMA-Female Jack (non-bulkhead) at the other of the cable- threaded barrel and no pin

SMA-Female Jack (non-bulkhead)


The U.FL pigtail can connect to a SMA-Female Jack Bulkhead at the other of the cable- threaded barrel, flange, nut, washer and no pin


The U.FL pigtail can connect to a RP-SMA Plug at the other of the cable- typically hex barrel, thread inside no pin

RP-SMA Plug


The U.FL pigtail can connect to RP-SMA Jack at the other of the cable- threaded outer barrel, pin - this version is a bulkhead with flange, nut and washer

RP-SMA Jack (bulkhead version)

I hope this helps out in identifying the right cable. Please contact us at EAD for your U.FL to SMA adapter cable requirements.